Difference between revisions of "UWT-100 Wrist Lanyard"
Jump to navigation
Jump to search
m |
m |
||
| Line 1: | Line 1: | ||
| + | [[Category:Universal WiFi Throttle]] | ||
[[File:UWT-100 Lanyard.jpg|thumb|Correct installation of the wrist lanyard included with the UWT-100 Universal WiFi Throttle]] | [[File:UWT-100 Lanyard.jpg|thumb|Correct installation of the wrist lanyard included with the UWT-100 Universal WiFi Throttle]] | ||
You may find yourself among the many UWT-100 users asking the question: "how do I attach the wrist lanyard to my UWT-100?" | You may find yourself among the many UWT-100 users asking the question: "how do I attach the wrist lanyard to my UWT-100?" | ||
Revision as of 20:40, 10 March 2020
You may find yourself among the many UWT-100 users asking the question: "how do I attach the wrist lanyard to my UWT-100?"
There is no need separate the case or remove any screws to install the lanyard. Please follow the steps below.
Process
- Slide the thin loop completely through one side of the bottom opening until it emerges from the other side.
- Send the entire wrist lanyard back through the thin loop.
- Pull tight to cinch the loop close to the bottom of the throttle.
Please note: There is a small plastic insert inside the lanyard loop. This piece is essential in keeping the lanyard strap secure within the throttle. Please do not remove this piece - we'd like to eliminate the possibility of any vertical derailments of your throttle.
