Difference between revisions of "Diesel Version 5:CV 27"
| Line 1: | Line 1: | ||
| − | == NMRA CV 27 | + | == NMRA CV 27 - Decoder Automatic Stopping Configuration == |
Used to configure which actions will cause the decoder to automatically stop. | Used to configure which actions will cause the decoder to automatically stop. | ||
Bit 0 = Enable/Disable Auto Stop in the presence of an asymmetrical DCC signal which is more positive on the | Bit 0 = Enable/Disable Auto Stop in the presence of an asymmetrical DCC signal which is more positive on the | ||
Latest revision as of 20:25, 19 September 2018
NMRA CV 27 - Decoder Automatic Stopping Configuration
Used to configure which actions will cause the decoder to automatically stop. Bit 0 = Enable/Disable Auto Stop in the presence of an asymmetrical DCC signal which is more positive on the right rail. “0” = Disabled “1” = Enabled Bit 1 = Enable/Disable Auto Stop in the presence of an asymmetrical DCC signal which is more positive on the left rail. “0” = Disabled “1” = Enabled Bit 2 = Enable/Disable Auto Stop in the presence of an Signal Controlled Influence cutout signal. “0” = Disabled “1” = Enabled Bit 3 = Reserved for Future Use Bit 4 = Enable/Disable Auto Stop in the presence of reverse polarity DC “0” = Disabled “1” = Enabled Bit 5 = Enable/Disable Auto Stop in the presence forward polarity DC. “0” = Disabled “1” = Enabled Bits 6-7 = Reserved for future use.
- Note If the decoder does not support a feature contained in this table, it shall not allow the corresponding bit to be
set improperly (i.e. the bit should always contain it’s default value).
| Decoder Automatic Stopping Configuration | |
|---|---|
| Range of Values | RANGE OF VALUES HERE |
| Default Value | DEFAULT VALUE |
