Diesel Version 5:CV 28: Difference between revisions
Jump to navigation
Jump to search
(Created page with "== NMRA CV 28 (Bi-Directional Communication Configuration ) == Used to configure decoder’s Bi-Directional communication characteristics when CV29-Bit 3 is set Bit 0 = Enab...") |
|||
| Line 1: | Line 1: | ||
== NMRA CV 28 | == NMRA CV 28 - Bi-Directional Communication Configuration == | ||
Used to configure decoder’s Bi-Directional communication characteristics when CV29-Bit 3 is set | Used to configure decoder’s Bi-Directional communication characteristics when CV29-Bit 3 is set | ||
Bit 0 = Enable/Disable Unsolicited Decoder Initiated Transmission | Bit 0 = Enable/Disable Unsolicited Decoder Initiated Transmission | ||
Revision as of 20:32, 19 September 2018
NMRA CV 28 - Bi-Directional Communication Configuration
Used to configure decoder’s Bi-Directional communication characteristics when CV29-Bit 3 is set Bit 0 = Enable/Disable Unsolicited Decoder Initiated Transmission “0” = Disabled “1” = Enabled Bit 1 = Enable/Disable Initiated Broadcast Transmission using Asymmetrical DCC Signal “0” = Disabled “1” = Enabled Bit 2 = Enable/Disable Initiated Broadcast Transmission using Signal Controlled Influence Signal "0" = Disabled "1" = Enabled Bits 3-5 = Reserved for future use. Bits 6-7 = Flag Bits, Reserved for future use
- Note If the decoder does not support a feature contained in this table, it shall not allow the corresponding bit to be
set improperly (i.e. the bit should always contain its default value).
Lua error: Internal error: The interpreter exited with status 1.