UWT-100 Wrist Lanyard

From Train Control Systems Documentation
Revision as of 21:07, 11 March 2020 by Skoffel (talk | contribs)
Jump to navigation Jump to search
Correct installation of the wrist lanyard included with the UWT-100 Universal WiFi Throttle

You may find yourself among the many UWT-100 users asking the question: "how do I attach the wrist lanyard to my UWT-100?"

There is no need to separate the case or remove any screws to install the lanyard. Please follow the steps below.

Process

  1. Slide the thin loop completely through one side of the bottom opening until it emerges from the other side.
  2. Send the entire wrist lanyard back through the thin loop.
  3. Pull tight to cinch the loop close to the bottom of the throttle.


Please note: There is a small plastic insert inside the lanyard loop. This piece is essential in keeping the lanyard strap secure within the throttle. Please do not remove this piece - we'd like to eliminate the possibility of any vertical derailments of your throttle.

NzMX1VmOJ9Q